Laboratory Safety Manual

SECTION I - SECTION II - SECTION III - SECTION IV - SECTION V (APPENDICES)
II.Cover | II.A | II.B | II.C | II.D | II.E | II.F | II.G | II.H | II.I | II.J | II.K | II.L | II.M | II.N

Section 2 L

L. Inspections

  1. Safety and housekeeping inspections should be performed at least quarterly by the PI or laboratory supervisor. A form which may be used by the PI or lab supervisor to perform these inspections is presented at the end of this section.

  2. Environmental Health & Safety also conducts periodic laboratory safety inspections according to an established schedule and upon request.
    1. EH&S inspections will include a general safety and chemical safety audit and a review of the Chemical Hygiene Plan.

    2. Unsafe practices or conditions will be reported immediately to the PI or laboratory supervisor. A safety audit report will be sent to the PI or laboratory supervisor with recommendations for corrective action.

  1. The Washington State Department of Labor and Industries, the WSU Fire Department and other regulatory agencies may also conduct safety and health compliance inspections.

  2. A sample inspection form which may be used by laboratory supervisors or Principal Investigators is presented at the end of this section (hard file reff. page II-23). A similar inspection form may be used by Environmental Health & Safety inspectors in performing laboratory surveys.
Table of Contents PDF Version Previous Page Next Page